Search results

I like what you did with this, great plan and setup! How much does it weigh? I would like to see a few pics of the awning setup. Will you go basic or full blown on the interior and amenities?

I'm thinking about voting for it because it's doing a burnout!

You were not! Exelent job now!!

Good job getting it done!

The flasher module is located on the left fender well under the hood, the ground wire is grounded by one of the bolts that fastens the module.

Check the ground on the flasher module on the fender well, the flasher module may be going bad also.

Their at the bottom of the window assembly frame on each side, use a small Phillips head screwdriver.

Truly the best bobbed deuce build I've seen, lockers front and rear!

It screws into the top of the master cylinder cap (with shorter nipple than in pic), with a plug in the top for power bleeder attachment.

Hope you get better in time to come hang out!

We can all go to Sonny's after!!

I put mine on the firewall, Built a manifold for the top of the mc cap for power bleeding Capability.

Which transfer case does it have?

Are you planning on using same 80/90 in your trans and transfer case?

Any brand will work and synthetic is way exspensive. If you had a wheel dolly you could skip pulling wheels and just pull the axles (rear) and bearing nut and roll the whole wheel set and hub assembly off as one unit, saves alot of time and labor. Fill a large Zipp lock bag up with grease and...

Just clean and inspect, most likely they'll be fine. Gl1 in the trans and transfer case and gl5 in the diffs.

Not all Sherwin Williams stores sell industrial coatings.

That setup worked really well! How much strap and what size did you get? Congratulations on your successful recovery!

No, most led light applications have electronic circuitry, it depends on that.

What water heater will you use?