Search results

Does that tag mean that it is bored .075 in each cylinder?

Do you have 12 volt at the diamond on the front firewall? Sounds like fusible link is melted.

Worn valve guides in heads allow exhaust to come back up between the valve and guide and prematurely "cook" the valve seals and make them brittle.

Check all connections at batteries and starter. Even though batteries are new load test them. Starter or starter solenoid may be bad. Remove starter and have it checked. Report back.

Is there enough room when sliding transmission and transfer case back on 4 inch bolts when changing flywheel to remove torque convertor and change front transmission seal?

It is very hard if not impossible to replace the knowledge of experienced mechanics who share with fellow enthusiasts!! We all miss you Rustystud!!!

Looks like some one put blinker fluid in the bearings instead of grease and it has malfunctioned and stays on all the time! :LOL:

Looks good! What part of Texas are you located?

One of the new aluminum heater cores properly installed and sealed will provide nearly as much heat as an August day in Oklahoma! :LOL: Well maybe not quite that much but it is a lot warmer in cold weather!

Are you sure both wheel brake cylinders are the same bore?

I have cleaned diesel nozzles at pumps with ether because they were so nasty. Works good. If you think diesel was bad try the Seafoam or keep adding ATF. It might still free up that injector. Maybe try not driving it so hard for a while. I would put in the Seafoam in a nearly empty tank and run...

Try a quart of Seafoam to a tank of diesel.

Dexron II or III is what I always used. I would also get some seafoam and use it pretty strong if ATF doesn't work.

It doesn't look like a good place to be sitting if that filter ruptures!

If my foresight was as good as my hindsight I would have 20/20 vision out of my backside! :LOL:

Welcome from Western Oklahoma!

In

What kind of wrenches you got that stand up to 5 foot cheater pipes? :)

Go to John Deere and get a can of multi purpose spray lube and soak those fittings several times. This product is a penetrating and lubricating oil combined. It costs about $8 for a tall can. I use it on the farm all the time.

Me too for about 42 years now!