Search results

I talked to Tigger today after he got back from fighting the fire all morning. I too was under the impression that because I only burn hardwood that is seasoned I was good. After a chilling conversation this afternoon, I checked the fireplace and did some research on the web and I have a...

Looks great, makes me want to move back to Michigan so I can plow snow roflrofl

GMANN and Hardimpact did you introduce yourselves on the forum? Go say hello to everyone at the following link. http://www.steelsoldiers.com/forumdisplay.php?35-Requirements-For-New-Members

Pick-up your vehicle and get the SF97. If all goes well we should have a change in the law by end of March.

No posts with pictures are not moderated before they appear. We have had some site problems which could be attributed to the delay but please try again.

Sweeet! nopics

Lets tell the truth guys, Patracy changed this per Zouts instructions, seems you were spending to much time in Chat and not enough in the Garage working on the WC restore roflrofl

Seriously???? The WAIT light does not come on when you engage the ignition? It will only come on if you engage the ignition and then press the accelerator pedal? WOW that is messed up. Go to the CUCV stickies and start looking at the wiring diagram. They would have had to put a...

Darn I tested and no more fishing today. Now I have to go back to work :(

That winch setup is SWEET!

Houston we have a problem, another BMY truck purchased in GA that can not be registered.

Found It, Thank you Warthog! HOUSING PRESSURE COLD ADVANCE (H.P.C.A.) All pumps are equipped with a Housing Pressure Cold Advance solenoid. (Figure 4-67). This component has been designed to allow more advance during engine warm-up. It consists of a solenoid assembly and a ball check return...

See DogHead is right, the internet is full of Sh..t. I thought we had an electric choke on the engines. After spending 10 minutes in the TM I do not see one :( So something engages the engine to idle at a higher RPM for a period of time before it warms up? So inquiring minds want to know...

The glow plug is activated by the ignition circuit and not the pedal. :) Proper procedure is as follows: 1.) turn key on, wait for glow plug to cycle and turn off 2.) Press pedal all the way to floor and release (engages cold advance and fast idle) 3.) On cold mornings, below 30 press all the...

I got in via chrome this morning at 8:48, you have to sign away your first born, (which is fine in my case) but you do get in finally.

I would like to see those calculations to double check the math :)

Call ups they are giving out gift cards to those that had their Christmas ruined :)

Checked on the drying results this morning. The surface has begun to harden, slighty still tackey where thick. The epoxy sealer has the same properties as an oil based varnish. I am going to need a second coat and sanding in between coats. This stuff runs as bad as varnish

Dang I knew I was missing something, dragged it all in workshop. The yelling you hear is my wife about the smell in the house :(

Got a little excited and through down the epoxy coat, not drying very well at 50 contrary to painters advice :( 2 hours still wet