Search results

I may wait for yours. What kind of lamping or power rating are you considering on both? For example, 100w x 6 (H4), and LED of 98 3W X 2 rows? I'm just making this up, but truly wondering the intended lighting plan. Earlier than November would be fabulous, like now. You were right on the...

The crane mounts with 8 bolts, but one could just use the 4 you mentioned to pick your silly a$$ up by your belt loops.....and your little pump too!

Come on boner. Grow a set, pull your pump off, and disassemble it. Are you waiting until I finish my bed crane in case you need to pull your engine?

Could be the trans pump front seal, or the torque converter also. Old style torque converters had a drain plug, I have no idea if the Allison trans has that. Either way, it doesn't really matter, because you are going to have to split the engine/trans junction to find out and fix it.

Sounds like voltage regulator is bad or going bad. They are available separately. Electronics typically start to flake out when hot before total failure. Also, I notice my voltage gauge goes high if I accidentally shut the battery switch off before the engine on my 925A2. Not sure if this is...

You're fine. The horn on my 925A2 recently did the same. WildChild467 took it upon himself to dig into it for me, and he found there is a diode just under the horn, I believe on the ground side, and this was weak/bad. By simply disconnecting, it resolved the issue. But, thinking it is a...

Yes, read the previous 345 posts. Your common issue and its resolution is discussed. Reverse feels faster because it is a 10:1 ratio, vs about half of that in first gear. 2000-2200rpm is the governor limit on engine speed, the accelerator pedal is simply a request input, the governor is the...

One thing not mentioned is that all of the shavings are of the same thickness, and maybe the same width, but different lengths.

Kind of like all the rounded edges on the 1/2 pound of metal shavings that came out of your pan when we drained your LDT's oil? F O dude! At least I know the difference between fine and course threads. Yes, I did pull all the wires off the pole with my 925A2 getting excited to drive my...

I ordered the Vestil WTJ-4, rated for 2,000lbs. Will replace the hand winch with a powered one, and may possibly shorten it so the beam can sit level with the top bar of the troop seats. Then it is not sticking up 20" over them at the rear of the truck looking all goofy like. Went with the...

Truck sales are live again. I bought my M925A2 off an individual who first bought it from GL. Sure, I paid a few grand more, but the risk was near zero, and for me that was worth it as I just wanted a single good running truck, and that is what I got. From an individual, you can actually test...

Typical high side for R134a is approximately 2 x ambient temp + 20%. Easiest if the fans are just on continuously when the A/C is on. Secondary way would be to trigger the fans on/off with the compressor clutch. Third way would be a high pressure switch trigger as mentioned above. All are...

Just kidding. But, your skin does need a minimum thickness to live here.....

Get a room.

You sound just like Cat's A$$ on this board...

That clicking and the 11V sounds like dead batteries. There is not even enough power being supplied to hold the solenoid engaged against its internal spring. Your load test seems OK. Was the 11V drop measured at the starter? I am guessing so from the video. Repeat the test and measure the...

Working for an OE supplier of both automotive and MD/HD starters, and overseeing a HD starter warranty return division that does 100% warranty retention and analysis may have something to do with it. Load banks work, but the vehicle starter itself is the perfect load bank. You can't get more...

This entry is an F up.

It is in the sticky, and yes you can get it at NAPA.

Open circuit battery voltage means almost nothing. Best battery health indicator is to measure the voltage drop under load during cranking. From your YouTube video, it seems like bad batteries. The CCA rating of a battery is a measure of how much current the battery can put out for a specific...