Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
Can anyone recommend a good source for a th400 rebuild parts kit as well as the torque convertor for my M1009? Nothing fancy, just factory spec. Thanks.
I am having trouble with the low oil pressure shutoff circuit on my generator. After running 5-10 minutes, the low pressure light comes on and the engine shuts down. Let it cool off, an it starts and runs till it warms up again. Has plenty of oil and the filter is clean. It shutting off...
May need a genset picked up at Ft Meade first week Feb. Needs transported to Birmingham AL or held until I can pick up during Aberdeen show. Dimensions are: 35x35x17, wt 585lbs. thanks
Can anyone identify this possible radio shelf? It fits to the rear of either wheel well on a M1009. The only markings are cage 67032 ( General Dynamics C4) and 82-2734594-2, which I presume a part number.
2-3 November 2012
Annual Dixie Division Military Vehicles Club Fall Rally and Business Meeting at Tannehill State Park in Bucksville, Alabama.
The annual Fall Rally and Swap meet for the DDMVC. Some of us will be there setting up on Thursday. Tannehill State Historical park is off exit 100 on...
Today I started some maintenance on the front axle of my m816 (pack bearings, new seals, boots, etc). This axle has the Bendix type joints ( four outer balls and one center ball). The -34 says to check the ball races for excessive wear, but doesn't say what is excessive wear. Anyone have an...
Could someone provide me with the length of the spacer for the long bolt on the passenger side alternator? Mine departed for parts unknown while doing a replacement. Thanks
I have a electric wiper kit as found on the M35a3, but no installation sheet. Any one have one or a link to one? I searched the site, but the only reference is in a thread in 2008 linking back to the manuals section of the old site.:roll:
In searching the site for 5-ton wheel bearing numbers, i have found 593 and 593a for the inner, and 592,592a for the races. What is the difference between the numbers with "a" and the ones without? Are they interchangeable?
Before using the starting aid on my M816, I decided to inspect the system for loose connections, etc. As part of the inspection I pulled the glow plug and the element was burnt in two. Thinking it may hav been subject to excessive voltage, I checked the power at the resistor. 12v into the...
I recently aquired a towbar which I need help identifying. Th OAL is 87 inches, and non adjustable. It is bigger than a medium adjustable. The pin holes measure 1 1/8" in diameter, as opposed to the 1.5" of a heavy towbar. Th spacing at the foot brackets measures 1 7/8".
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!