Search results

After running into a problem with my filters being bypassed I finally got around to installing somthing that I know works. now if i could only get the stupid truck to run right..

I am looking for a tm on how to shim the input and output side of a diff I can't seem to find one. Any one know of one or know how to do it?

I am needing annther center diff section if anyone close to oregon has one. Mine spun the bearing. The truck is listed for sale and need to get it fixed as soon as possible.

other then a bad gasket a missing pto and a few cosmetics I am done with all my work on my truck. Here are a few photos from the finall test drive.

I have access to 1000 or so gallons of slop diesel at work this consists of: BILGE WATER diesel, new engine oil, used engine oil and used hydraulic oil. I am wondering what I should do in order to safely run this in my deuce. I have bottom drained the slop tank of most of the water till it...

Well I finally got most of the problems worked out on the deuce. I've replaced all axle seals and changed out all fluids except for cooling as I still have to check on the thermostat. Ive changed both fuel and oil filters and greased all the fittings I can find. I Just got the bed mostly...

This is a continuation from my "how bad did I get burned thread." I have sense pulled the differential. The bearings were bad and got chewed up that was the source of my leak. Luckily It doesn't look too bad one small chip out of the pinion gear. I think I can reuse them but not too sure I...

picked it up about 200 or so miles away had wife and babey drive me up and follow me back smelled gear oil stoped looked oil everywhere now im broke down in pacific city oregon at a hotel i cant afford trying to figure out how to get to coosbay oregon or at least florence it runs fine well runs...

I've been looking to buy my first rig but have a few questions about them. don't all m35a2's come with a high and low transfer case? I've seen them advertised with hi low and some not. also some have the airshift front axle and I've heard that if you don't have an airshift front axle then its...