Search results

I checked the Midwest Military site and Mr. Bizal sells a front and a rear wiring harness. Might be looked at as a bit pricey but when you factor in all your time and effort to not have to source the parts and fabricate it yourself it doesn't look bad at all. Plus it will get you back on the...

Army TM 9-8030 Operation and Organizational Maintenance ¾ Ton 4x4 Cargo Truck M37 May 1955 Paragraph 141. Fuel lines and Fuel lank Vent Lines a. General. If replacement fuel lines are not available as assemblies, use 5/16-inch seamless tubing, flexible conduit, and 5/16-inch inverted flared tube...

Gates 23976 flexible gasoline fuel filler neck hose available at O'reilly or NAPA (NBH 1055) about $30 a foot. Suitable for use with gasoline, gasohol blends of ethanol, methanol, ethers, diesel and biodiesel to B20. ID is 2.25" (2-1/4" ID).

Here' the MIL-SPEC on the wire.

I've got a 1952 M37 also, along with two M35A2's. The M37 uses the Douglas metal connectors while the M35A2's use the rubber Packard connectors. Most of the wire I've run into on these military vehicles has been the 14 Gauge (Prestolite) M13486/1-5 wire. I can't recall running into any...

Alternative part The parts manual lists the two shutoff valves used on the personnel hot water heater hoses as NSN 4820-00-026-8473 CAGE code 90940 part number 0637127 COCK, DRAIN. An alternative part under that NSN is part number AT35831 COCK, DRAIN from Deere & Company (John Deere). I got one...

Thank you all very much! Thank you all for the help. I took off the plug on the line at the fitting at the top of the fuel pump and turned on the accessory switch and no fuel came out. Checked the plug at the fuel pump and got 26 volts DC when I turned on the accessory switch. Took the top...

If the pump is working with a new dry primary filter and the lines dry any estimate on how long it should take for fuel to appear at the secondary and final filter asembly bleed valve? Is 4-5 minutes excessive?

Sounds like it couldn't be anything but the pump........

Hard to hear anything over that ferschlugginer low air pressure horn. Darn thing worked before I decided to get fancy and change the primary fuel filter to the spin-on type.

Can the in-tank pump lose "prime" if the lines are dry?????

Should I remove the new filter and see if it pumps to that point from the tank as a first step?

Changed out military primary fuel filter for the spin-on one found on other threads on this forum. Fuel lines were dry for a couple months. Tech manual says to open the fuel bleeder valve located on the secondary and final fuel filter assembly, turn on the accessory switch (low air pressure horn...

Overheating I would definitely be concerned. Tech manual operating procedures says normal operation temp gauge should be 180-200 degrees F, and to stop engine immediately if engine temp rises sharply to 210 degrees F or more or stays below 180 degrees F. Mine was having the tendency to climb...

Another difference I was doing some looking on the web a while back and I believe the A3 bed is the same as the A2 bed but it might have the cargo tie-downs installed as well as an extra "cut-out" on the rear face of the bed that mount 3 red side marker lights and the trailer connector facing...

Parts List Drawing The installation drawing for the Mini Light Kit is TACOM 19207-12301024 which I have never been able to find (can someone post it?). Attached is the parts list drawing 19207-12301023 for the Mini Light Kit. I used the parts manual TM9-2320-361-20P page 324-1 under Group 33...

LDT-465-1D Parts Manual The LDT-465-1D has its' own parts manual (attached).

Weight TM 9-2815-210-34-2-1 Table 1-4. Data Application lists the weight of the LDT-465-1C multifuel engine at 1,650 pounds.

Oil Pressure range TM 9-2320-209-10-1 lists the startup oil pressure is 30 to 40 PSI. TM 9-2320-361-10 Section 2-4 says the normal oil pressure range is 10 to 75 PSI. Looks like the safe play is to have the 0-120 PSI transmitter and gauge rather than the 0-60 PSI setup.

Here is a list of the current manufacturers/vendors on the Qualified Products List (QPL-46176) for MIL-PRF-46176, Brake Fluid, Silicone, Automotive, All-Weather, Operational and Preservative. Manufacturer Designation AJ-331 Source Name A-J CHEMICAL, LUBRICANTS & EQUIPMENT COMPANY A J CHEMICAL...