Search results

M929A2 . Tachometer works. Hour meter does not. White connector with two leads behind tach housing not receiving power. Guessing that connector should have power when the engine runs to drive the hour meter. Need to know where to look. Is it fused? What is its basic source and path? Looks...

Touch the brake pedal and all of the lights go out. The breaker resets and lights come on. Will repeat consistently. Have looked for bared wires , have removed and tried without brake light bulbs. Cant find a cause. Everything I can see looks ok. What can I try next? M929-A2.

Trying to complete the project and having trouble with plumbing the tie in to the existing hydraulic system. Can't find any help in the TM's. Would like to know if the original pump is gear type direct displacement . Also would like to know if the dump body valve is spool open center or poppet...

I need to remove the flange from the steer axle pto output shaft so I can fit up my snow plow frame braces to the frame. Took the cotter pin out of the castle nut but can't figure a way to hold the flange from turning while I get on the nut. Is it a RH thread? How to hold the flange?

Need any advice available on this. I have a plow and a frame hoist from an old town truck.Figured I'd keep the same height and attach it with some front frame extension. Want to control the hoist and angle from inside the cab so I'll need to find some valves.

My first 5 ton has arrived to be prepped for snow removal on the 3 mile driveway. Got the engine to run thanks to this forum for the fuel system priming advice. I have no air building on either dash gauge. Shop air application shows me a gladhand shut off valve stem missing/leaking and a large...

M929 not running from Ft Indiantown Gap to my house Towanda, Pa. Need to schedule soon. Thanks! 607-426-2344 Jim

Looking to set up for whole house backup with an automatic transfer switch (Asco 300 series). Have a hand drawn diagram for the remote circuit to start and stop the gen set through a series of 24 volt coils. Would like to verify since it is hand drawn and it's a first time deal. The circuit ties...