Search results

The batteries in my M1028 just died. This contest is right on time. Thanks for sponsoring.

IN

IN

Dock Rocker, The width is 75 inches. The same size as a twin mattress. Hope this is the right number you were looking for.

I will measure one of mine when I get home from work in about 4 hours. Unless someone else does it before hand.

Very cool, looks like it will fit just fine. I could use one of those myself. The insides of my mast were rusted and frozen. Spent quite some time trying to free them. Finally, I just gutted it and drilled holes for pins in every section. I have to manually raise mine section by section. No...

Side note: I gutted to AC unit and installed a small 120v, 5000 btu window unit. After I drilled some breathing holes in the sides, it works like a champ.

I gutted mine and rewired it to 120v, and I converted one end of the original power cord to a 3 prong. There was no ECU. It did have the lower 19" rack, and I added the top rack on the table. I also installed a bunk on the right side. I still need to make a Cushion for it. I installed a...

What are your plans for yours?

Thanks, I put a lot of work into it. Here is what it looks like currently in the shelter. I have just updated the backend with another radio, monitors and I built two remote wireless CCTV cameras with 1.2 mile line of sight range. I will take more pictures when I finish the wiring.

I have a similar shelter as yours. I picked it up from Davis-Monthan AFB in Tucson, AZ. There were two both mounted on M1028 CUCV. I purchase the camo truck. The other was tan. The camo one had the mast, the tan one didn't. I suspect you have the shelter from the other CUCV. They both came...

Thanks, I'll look for an A2 axle or trailer. See what I come up with.

My **** memory sucks since the TBI. My M105A1 is 6 lug, and the M101A1 is 5 lug. Thanks for the info on the A2 and A3, I guess I need to look for an axle.

You are correct, it is 8 lugs, the trailer has 6 currently. I haven't been able to find an axel the same length. I shorten the wheel well two inches per side to fit an S-250 shelter in it.

Has anyone converted an M101A1 trailer to accept CUCV Chevy 6 lug rims? If so, how was it done?

You are correct and I didn't chage the bearings. The cam was replaced because the Key on the CAM was broken off from a bolt on the water pump backing out and falling into the timing gears. The motor has less then 8k on it. inspected the bearings with a bore scope and they looked good. That...

I had 7 lifters that were hard to remove from the block, I got 4 out, 3 are still in there. The 4 I removed have some mushrooming around the bottom by the rollers. Thats why their hard to pull out. I am replacing them all, does anyon have any ideas on how I might get these out? I already...

I will do that

Well, here it is. As soon as I get my motor back together in my M1028, I am going to start on the conversion to a camper. Still looking for a good price on solar panels.

Tinstar, Thanks for the advise, I am going to pull the heads, and I was given new lifters from a local MV guy