Search results

I could use some help from someone that has rebuilt a 6.2. I'm trying to rebuild the engine from my M1008 and the main bearing diameter are all different sizes. I put the main caps on without the bearings installed and the hole the bearing goes in ranges from 3.1389 (#5) to 3.1424 (#1). The GM...

I bought a M1028 last week and the generator /welder was gutted from the back. I could use some guidance from those wise on these things. Would it be better to use the space for a newer stand alone engine driven generator/welder? If so, which one? (NP208, no PTO) Should I replace the original...

Can anybody tell me what this was used for? It was slid over the end of the steering knuckle and the tie rod end went through the hole in the middle. It added the forward hole that would have moved with the steering but I can't fathom what for. It came off of a 1990 K20 Suburban 6.2l diesel that...

I read all 15 pages of the Charging system sticky and I still have a question. My front battery is not charging. The alternators were bench tested good two weeks ago and the batteries are tested good. I replaced the Gen 2 light, Voltmeter relay, Gen 2 relay, and now the positive bus bar is...

I found this TM for STE/ICE along with the design guide. I noticed some people in the CUCV forum were asking for it.