Search results

Does anybody have a link to properly mount the rear seat bases, I have a helmet top in a two man configuration that I would like to add the rear bases to. I have a complete set for the rear bases but no hardware. Any help would be appreciated

Was going over a HMMWV that I recently bought and noticed the line from the Cadillac valve has been bypassed, any ideas why this was done?

So while I have been working on my M1009, I acquired this truck. It’s a 1992 6.2 diesel with factory radio and AC. 13,000 miles and is all original. It has a power inverter behind the seat for a 24 volt radio.

Looking at a 1123 with the 6.5, motor has the intake manifold off as well as the fuel injector lines disconnected. Did not do a complete inventory of everything under the hood. standing Water on top of the block. Wanted to get a ballpark of what it would cost labor wise to swap the engine out...

Like the title says, Is there a source for replacement fuel tanks? Looking at one that appears to have a fuel cell in the bed

I have been looking at a couple of Hmmwv that are local to me, one has a SF-97 the other doesn’t. Both are non running and I am looking at these as a long term project. Can I title a Hmmwv in the State of Texas with just a bill of sale?

Due to the hot weather lately the CUCV has been sitting in the garage, today was nice so I thought I would take it for a drive. It started right up, idled nicely at first for a few minutes before pulling out of the garage I noticed a little white smoke in the exhaust. Hit the street and almost...

Does anybody know the thread pitch for the bracket in the rear of the M1009? I have the jerry can, bracket and strap just need to figure out the thread pitch.

I removed the old side windows in the CUCV to repaint the fiberglass top, I have new rubber gaskets to install the glass in but need to know if I need to use a adhesive or sealant to install the rubber

Currently repainting the original rims, there is a chrome set on the vehicle now and I am looking for black center caps, open for the front tires and closed for the back tires, I can only find chrome ones in the LMC catalog

Is there anything different that needs to be done if the M1009 is still the 24v original set up

Discovered that the “Main light” 30 amp fuse slot had melted/ distorted in the past. The fuse will not fully go into the slot, I discovered the problem when I was driving and suddenly lost my driving lights . Is there a way to repair the slot? Carefully cut the plastic to allow the fuse to be...

My M1009 has the spare tire bracket mounted inside but is missing the smaller pieces( The ones that secure the tire to the bracket) Is there a source for these or are they unobtainable

I have been pouring over the FAQs, and sticky threads, and I apologize for being direct but I have a couple of questions, It’s 75 degrees out and I go outside to play with my new to me M1009, I turn the ignition key and the wait light goes out in less than five seconds, I turn the key to...

After waiting and searching I have brought home a 1984 M1009, 79,000 original miles. I plan to restore her to her former glory. It is running and driving, a few issues that I have come across so far. When you use the left turn signal it causes all four turn signals to flash. The headlights need...