Search results

I am in the process of rebuilding my front end, and found that the kingpin bushings are too small to fit over the kingpins. I double checked the part numbers, and everything is correct. Am I missing something???

Im having a lot of "clunking" when turning, both left and right. Im thinking it may be time to replace the kingpin bushings. Anybody else have this issue? Tie rod and draglink ends appear to be good.

Are there longer wheel studs available for the front wheels? I am running 395's on PLS-T wheels, on peashooter's adapters. My lug nuts are pretty much flush with the end of my studs. Kinda worried about them backing off, or snapping off. Any info on where I can get a longer set would be greatly...

Anyone know the part number and where to get brake bleeder valves? Thanks in advance.

Thinking about bobbing my deuce and wanting to add 4" of lift to it. Are there springs I can buy that will give me that height, or am I going to have to make custom leaf packs?

Does anybody know the torque specs of the PLS trailer (M-1076) studs that hold the rim together.

Any M35a2 6x6's out there lifted. I know 395's are as big of a tire that they can run on the rear, but they tend to get stuffed up into the bed, and the extra room could definitely be used up front. I know it can be done. Just wondering if anyone on here has. WITHOUT SWITCHING TO 5 TON AXLES!

Anybody running longer wheel studs on their deuce? If so, where did you get them from?

Anybody running longer wheel studs on their deuce? If so, where did you get them from?

Is it better to use diesel or gasoline to mix in with WMO when using for fuel?

Anybody around the Stratford, CT area heading west, anywhere near New Mexico? Needing two rims delivered.

Does anyone know what rims these are. I'm looking for a set of rims for the front of my m35a2 that are a little wider to prevent rubbing on my steering linkage. I'm running 395's

Anybody ever use longer wheel studs to add wheel spacers to keep their tires from rubbing the steering linkage when turning sharp to the right? Or any recommendations on wheels with more offset to keep from rubbing? pics would be great! I currently have FMTV wheels that have been cut and welded...

I have been looking everywhere for replacement ducting for my heater intake (between fan and Intake). Any help would be greatly appreciated. Thanks.