Search results

Need help please. I have a M920 1980 model with Cummins 400 and I need a fan clutch kit for the Evans clutch. I bought a EVANS TEMPCON FC212024 ENGINE FAN CLUTCH REBUILD KIT FC134X RK134 but it look like the clutch disk is wrong. Hoping you can give me some insight on what I need or if the one...

Got a new pump plumbed in and I am up running now. Thanks for the information simp5782

Just checking to see if you were still on schedule to pick up the motor this week. Thanks

skip

skip

Will the original coupling shaft work with the new eaton pump? I'm assuming it will work , but I figured you would know for sure? Thanks

O right., thank you very much. Been watching your 920 build and have found a lot of good ideals for my truck. Thanks again

Thanks for the information. Would you have a part # for the eaton?

Question, Is the power steering pump on the M915 the same as the M920? The 915 is a 1984 and the 920 is a 1980, Thanks

in

I'm in. Thank You

Lots of good info here. Just starting to rebuild my 920 and you have given me a lot of ideals. May need to contact you for more info and parts if thats ok. Thanks simp and keep up the good work!

Hello, Does anyone have a copy of the repair manual for the MT654CR ? It's in a 1990 BMY 931A2 . I am having a reverse issue. Sometimes when I put it in reverse it will be a really fast reverse. It will kill the engine with the TC in high but will back up with TC in low but really to fast. Good...

Hello everybody, I need some information on the M52A1 Spicer transmission 6453. What I need to know is if the air valve on the transmission is suppose to supply air in all of the forward gears or just 1st gear and which end of the cylinder on the transfer case it is suppose to conect too. I...

Hey thanks for info. To answer your question on the run time I will use this truck 10 to 12 hours a day. During that time I will be loading a 7000 gal with the trucks pto and when loaded which takes around 8 min I will stop the pto and drive about 200 to 700 ft and reengage the pto and spread...

Getting ready to put a M939 PTO on a M931A2. It will be pulling a pump at 30 gpm at 1500 psi and running about 70% of the time. My first question is will the pto handle that load? The second question will I need to add an oilier to it?