Search results

I'm in

I got a measurement of @ 18.5" on the installed fan blade and @3/4" clearance on the fan shroud. The parts I used are AM general plarts and work just fine on my serptine belt set up.

My V belt fan is 19.5 and the serptine belt fan I have sitting around is 19.5. I didn't open up my engine to check, but it fits the fan shroud just fine. Don't make this harder than it needs to be. Call the vendors and ask? I listed the part #'s and a vendor.

The clutch bolts to the water pump and the fan to the clutch as normal. The clutch operates as normal. If you look up the pn's I listed you can see.

Thats to bad about Les Schwab , Must be one that doesn't work on semi trucks. The one around me did a great job balancing my tires and siping them. Guy that did the work got a work out. Its not hard to tighten up the steering box, there are a few video's on it.

Those look used to my old eyes, and you spend almost $100

Here's a description A fan clutch is a thermostatic engine cooling fan that can freewheel at low temperatures when cooling is not needed, allowing the engine to warm up faster, relieving unnecessary load on the engine. As temperatures increase, the clutch engages so that the fan is driven by...

I got my parts from Hummer parts guy. pn's 6013102 clutch and 6017546 fan. Its not a conversion kit, its what I figured out would work and it does. I did this when I got rid of the v belt set up and went serpentine. The noise is less and it keeps the temp down.

I'm in

I'm in

I am interested in doing this mod, my smart box hasn't failed yet would like to get ahead of the game. thanks

Benefits are the engine isn't screaming at 55mph and gearing is a little different.

IN

In

IN

What would HF be calling this tool, I'm not finding it on their website thanks

I have installed new windshields witch took 5 of them to get two that were not cracked, grab handles for the wifey, battery disconnect switch that that I'm not impressed with doesn't feel solid. and finally a tach that is a pos. I forgot I installed new side mirrors for a jeep, don't know about...

This must have been about the time I got mine an had a lot of trouble, mostly with shipping mistakes. I received a call from Advance Adapters about the length of the output shaft, seems it was a bit to long and causing failures. I trimmed mine to what he said and moved on.

You can adapt your old bracket with a file so that the square cable end fits in the old round hole. Just hand file it or use a dremel. It can be done just give it a look.