Search results

I have driven as far south as Madrid and spent a few days in Barcelona. I love the country it is a special place. I would consider living there perhaps in the future. The lifestyle seems to be very different but more relaxed. I appreciate the culture and the way that a feeling of national pride...

Looks like you are doing great work! Where in Spain are you located? In my travels there I have not seen any old USA military vehicles, but did spot some of of your indigenous equipment in convoy while driving between Bilbao and Logrono...

To be honest it looks almost as hard to work on in the Hummer than it must have been in the original car. Very cool idea and looks well done. Good luck it sounds to me like you thought this thru. Loved the simplistic explanations too gave me a good laugh that was sorely needed. I wrench on a...

Someone posted this elsewhere but it's worth a link again I think. Never would have thought this would work. https://www.locknstitch.com/

The dump truck?

I say it because have a similar problem with my deuce truck sits for a month and then shakes pretty good for the first 5 minutes or so once I hit 45 mph. After some driving it calms down until the next time out. Hot weather reduces this. Tires are not new but in good shape.

Tires would be my guess too.

On my truck the tube joint to the radiator was cracked. We rebrazed it along with other areas that had come apart. Seems pretty common prblem on these deuce radiators. It is maybe 1/4 OD and just fits in the neck there and it brazed in. The tube runs down the side of the radiator to let the...

I went thru this on my deuce a few years back. Decided to make new pins (6x) 0.010" oversize and ream out the bushings to clean up the wear. Worked out for me but had access to a machine shop. Needed new pins anyway they were worn. I could not find the bushings for the leaf springs either at...

Glad to hear you are doing ok now. You are right - Canadian Method all the way...

ALCO - honorary steam locomotives

I have one yet to install. Claims to work for multiple vehicles including M37. Out of stock at Eriks. Maybe give them a call? Google is giving me nothing. https://www.eriksmilitarysurplus.com/liswadcafrma.html

My experience a couple years back you are better off with a good used take-off. Bought one NOS from TNJ Murray and it did not fit. Was close but just not quite right. TNJ swapped me out for a good used take-off which worked. Of course long term this is not a viable solution...so it's a valid...

If it leaks from the top of the fitting you might be Ok. Mine leaked from where the fitting screws into the head.

The truck will run pretty good with a leak from a crack. Take a good look at #3 after you get it cleaned up. Seems to be a common failure point. As mentioned above, if it leaks around the fitting it is usually a crack and it cannot be repaired. The viton seals go under the head itself. If it...

Maybe the 8th circuit is for the receptacles on the front of the unit?

Movie "The Outpost" about the battle of Kamdesh had a lot of footage where the HUMVEE's are used as machine gun posts. Looks like the armored ones could take a hell of a beating from small arms fire...

Looks to me like it has 7 single phase 15A 120V connections and one 3 phase connection. Probably pretty useful on a jobsite.

I was curious as well. One type charges a capacitor after opening and uses that stored power to close the valve when you cut the power. Some energy is needed to maintain the charge in the cap...but less then maintaining a solenoid in the open position it appears.

Love that dump truck. Any more information available on that?