Search results

I received my new mounts in the mail today. they are not what i expected at all,they are very firm and not flexible at all. if you look for an alternative mount it will need to be almost solid.

I just found a source for aftermarket mounts that are much cheaper and just might be a direct replacement. not sure until i dig deeper. anyway they look good. can i post a link? if not look up "Barrys shock mounts" let me know what you think.

I am not sure about the date of MFG but i know it was rebuilt in Utah. the vibration was harmonic and it was more of a shaking motion moving near 1/4 inch or more at the top. the hertz meter and the load meter didn't survive the shaking. i temporarily helped the situation by doubling over some...

that is good news! my control box was shaking so bad i was concerned that the wires would break behind the control box

I found some still inside the expiration date. I watched some youtube vids of other MEP 002A running and the control box was stable so i stayed with the original design. my concern is that the wire harness behind the control box would give way at the connector.

I have contacted the manufacturer of these mounts. there is an expiration date on them so somewhere sitting on a shelf are some perfectly good mounts that can't be used because they are to old of have been taken out of service for the same reason. we shall see.

I found them!! Lord HT1-20 boy are they expensive!!!!

I think i need some new Vibration dampeners for my MEP 002A. the control box shakes more than it should. i temp fixed the problem by doubling over some soft rubber tarp straps and wedging them between the box and frame. anyone know who carries these parts?