Search results

You need to drill the holes a bit bigger. They should go on just fine. after looking at your photo, the circles might be bigger than the depth of your rail edge. would grinding down the circles work? Take a close look at how it is pressed on. You might have to tac weld it from the back before...

I see where your discrepancy is.

thanks for that info. i will have to take the current ones out to measure the hole. I guess it doesnt matter since I will have to redrill new holes.

it is a tight fit but yes it fits over everything tightly. I took everything appart so I will send you a photo later.

thanks for telling me what they were called. Took me 3 seconds to find after knowing that. 12339397-6 Mac motors has them for 79cents

I think i will need to find someone to mig the holes closed and cut new holes. does anyone know what the part number is for the screwable grommet?

the rails seem fine. It’s the holes on the a and b pillers. C looks ok.

Unfortunately this is not just a jiggle. I don’t believe the holes are in the same spot.

Hello, i was noticing that one side of my rails look lower. After removing the screws, it looks like there is a bushing and hole made from the factory. this is an issue for me because I have hard doors and it interferes with closing. Below are the left and right sides: are the holes...