Search results

I'm screwed up! I bought WRONG A1 I should have have got the TRC A1 attached is T1 & voltage adjustment control, I did not find S12 to find resistor. Should I buy TRC A1?

Thank you so much. I’ll check it and keep you posted, I did not know that 804B & 804A used either TRC or Libby Thanks again for the information

I have a Libby A1. How do verify correct T1, R16, and S12? Gen set MEP 804 B I'm assuming 804B uses a Libby and the 804A uses a TRC is this correct? My apologies for my illiteracy in previous threads I get to wound up and frustrated and using my cell phone doesn't help I would appreciate any...

How do I verify?

It’s in the response to post number two that’s the part number I shouldn’t have to change anything I don’t know!

The response to thread 2

It was post 1&2 I unable to forward I don’t know if you can see it?

I went with thru this subject when I ordered it let me see if I can find it thanks

I’m trying to find a previous post that gave me a EBAY part number it’s in one of my posts

Libby, I bought it on EBAY open box

I did not check for power before the relay swap, when I release S-1 I lose power and the hertz meter drops off.

I swapped out relays K-15 with K-14 same problem persiste although when I hold S-1 in the start position I do get 120 volt to the convinces outlet

I did swap out the relays K14 with K15 same problem although when I held S1 in start I do get 120 volt to the convinces outlet

It’s a good thing that with the unit running I can switch to start without running the starter

K15-7 24 V K15-4, no voltage on start The contact dose open and close with S1 start

A5-18 0 volts A5-19 24 volts A5-20 24 volts

A5-18, 0 volts A5 - 19, 24 volts A5-20, 24 volts

24 volts on A, 0 volts on B