Search results

No worries. That box is your problem then. It just goes between your column harness and the cab harness. You will note two extra wires on the column harness side but the same number of contacts as your cab on the cab harness side. I do not remember but you may be able to use your CUCV...

Did you install the delay control box? If not, install it. if I remember right, I did not install the box and the engagement positions on the switch act screwy. Installed the box and the probelm is solved. You can replace that turn signal arm and get rid of the cruise mess. You don't have...

I put a crack in my transmission about 4" from the rear that ran between the governor cover and the plug where a 2WD speedo gear goes. Built a new one and swapped it out. Good times!

Installed a sliding rear window in my 1059 (original 1031 with a bed from a 1028). Going to clean out the cab, POR-15 the floor and install the POR-15 bed liner in the cab.

Good times!

I fried a starter, cooked a wiring harness, took a nail in the sidewall of my tire, and put a nice dent in my M1009. then I pulled out the dent, replaced the harness and starter, charged the batteries, and have not finished the project.

My 1009 just received a tilt column, Grant steering wheel, tinted sliding side windows for the top, and recliners on the seats. Also installed the jack mount under the hood from an 87 K5. Replaced the exhaust and am working on a ram air kit for a shaker scoop for it. It has to run better with...