Search results

I created a new page on my website for installing the rear locker. There are 88 total pictures. http://hanksdeuce.com/rear_locker.htm

See Step #27 above. Below you will find discussion & pictures regarding the safety wire (and alternative) for finishing the rear locker install. I decided against safety wire on the ring gear nuts due to internal clearance issues with the differential housing. Any place that I tried to tuck...

Thanks. I have no clue how much a shop would charge to do this work. Your average 4x4 shop may or may not have the tools to pull the center chunk out of a Rockwell axle. I didn't really keep track of my hours so I can't even help you to figure out a labor total for a shop rate. If you...

No problem. I'm glad I figured it all out by deciphering the TM's. Maybe somebody will get some good information out of this thread if they decide on using an Ouverson locker for their M35A2. Who says it's my hand in the girly men gloves? lol :3dAngus:

19) Remove the bolt/nut/fender washers from inside the Ouverson Locker. 20) Reinstall the differential assembly into its housing. Verify your alignment marks! Everything goes back where it came from. Make sure to slide on the corresponding bearing retainer on the appropriate bearing...

15) Unbox the Ouverson Locker. Be amazed at what you are holding in your hands. Give yourself time to recover from the excitement. We don't need trembling hands here. 16) Place the locker into either carrier case half. I'm left handed so I chose the left side carrier case half. Don't judge...

6) Turn the differential housing upside down so that the bull gear is facing up. This makes it easier to work on. 7) Take your favorite hammer and a center punch or some sort of scribe to mark each side of the differential. I chose to mark a single dot on the left side and (2) dots on the...

I have a build thread with all of my modifications in it, but this breakout thread will be for those that don't normally read my build thread. It will help anyone trying to search for the necessary reading material so that they too can install an Ouverson Locker in any of their Rockwell axles...