Search results

What size tires? You definitely need cutting and or a lift!

Does the gen2 light come on at all? If not swap out the gen1 and gen2 bulbs to check the bulb. Also the contacts get dirty and or corroded on the bulb socket at the printed curcit board clean the board and socket then turn the socket several time to get a good contact. Hope this helps!

Thanks again for keeping me up to date on the alternator. The red primer is fine if you like red. Civy trucks didn't have any paint at all or just a very light coat of black paint from the factory. Personally I would just get a couple cans of spray paint OD Green or flat black and just give it a...

The red indicates primer. Your axles were replaced at some point and not painted! Let me know how your alternators work out for you. If they work out I will order two for myself. Thanks, Dwayne

It should up shift from first to second at about fifteen mph indicated and from second to third about twenty five mph indicated. Linkage has nothing to do with auto up shifting. It is a vaccuum issue. Start at the vaccuum pump. Disconnect the rubber hose and see if you are getting vaccuum. Then...

Thanks, I have been looking for a spare and I heard horror stories about getting the wrong one! I have been running Dexcool, the orange for two years now with no problem. You just need to make sure no green stuff is left in the system. Thanks again, Dwayne

Where did you get it and what part number water pump did you use?

Mine had the same problem, except after I tighten it up it still had the sound. Looked again and the front inside corner was rubbing the frame. Thanks to GL forklift the plate is bent and I was unable to bend it back in place. So I slit a two inch piece of fuel hose and slid it onto the shield...

I have the tilt steering column installed. The other parts I can get. Just didn't know where the wire the washer motor into the harness. Thanks!

No problem just here to help! The nuts holding on the spindle are one time use. I got mine at ace hardware. Do not use nylocks because of brake heat can melt the nylon. The rest is fairly simple. If you have a TM or a mid 1980's Chevy repair manual, it helps. I replaced all the bearings and the...

I bought a three inch piece on 7/8" hex stock at my local metal supply store used a socket a breaker bar and a piece of pipe about six feet long over the breaker bar to get the king pins to break loose. The socket for the wheel bearing nut I bought at napa. You need it to torque the bearings...

Any pictures of wiring changes needed for the washer pump in the fluid tank?

Why not leave the pintle hitch and just add a receiver hitch.

Don't feel bad I didn't even know these parts existed until fairly recently! I can't take the credit someone else on steel soldiers had it posted.

Battery charging post at www.pitstopusa.com. Ordered the bracket too.

Got the studs and bracket off of the Internet and just ran two long battery cables from the front battery.

M1031 mods Did a few mods over the weekend to my M1031. Made and installed a ladder to gain access to the roof, installed two flag poles, fixed an annoying rattle move the fuel tank shield away from the frame, and installed a 12 volt remote jump station so I can charge batteries to jump start...

Lucky you! Where I live if it isn't nailed down really well it walks off never to be seen again! I even have wheel locks so t hey don't steel my tires!

You can buy them new at autozone. About $25 for the ignition and $20 for a set of two door locks! Ignition key and door keys are different just like on a civy truck. Square for ignition round for the doors.

nopics