Search results

@royalflush55 is this what you mean? I just want to double check. The Hillman Group 180398 1 1 1 3/8-16 Whiz Lock Nut, 100-Pack https://a.co/d/4b34aGH Sent from my iPhone using Tapatalk

@ToddJK I’m thinking I could just check the tightness of those nuts every other week-ish. Sent from my iPhone using Tapatalk

I have a quick question. Is it safe/ok to use Ring Lugs on the battery cable ends for both batteries for both negative and positive posts? The Negative Post in the front battery has this type of connection/lug. Picture below. There’s a Post Adapter on it, which I could simply remove. Then cut...

@Mad Texan Thank you for the info sir. Where do you have that hooked up exactly? It’s a bit difficult to tell in the pictures. Sent from my iPhone using Tapatalk

@adf5565 Thank you for the info., that’s too bad yet still good to know! It seems the Blade Type of Switch may be the best option. Sent from my iPhone using Tapatalk

@Warthog @doghead would you masters of the CUCVs have any input? Sent from my iPhone using Tapatalk

@vanaisa I’m thinking of putting quick release disconnect battery terminals onto the Neg Post of each of the 2 batteries. It seems to be the sure and safest way. Or, I’ll just leave it as is and disconnect the batteries normally. If it the existing clamps wear out again, I’ll replace the cable...

@87cr250r I’m going to take a few photos to show how and what is hooked up to my two batteries. Let’s see if I have 12v Loads into the Rear Battery. Sent from my iPhone using Tapatalk

@cucvrus I’m terrified of frying anything, as mentioned above in the screen shot I shared! I’m thinking if I use a clamp on both batteries it would be over cautious, but still ok? Sent from my iPhone using Tapatalk

@cucvrus There you are! With that in mind, should I just put one of these clamps on the Ground Post for each battery? Disconnect them when working on the vehicle. Would that be safe? Sent from my iPhone using Tapatalk

@87cr250r Sent from my iPhone using Tapatalk

@cucvrus @Warthog @doghead Would you have any input? Could I just attach one of these to the Ground on each of the two batteries? Disconnecting the Grounds as a way to prevent any damage? https://www.facebook.com/commerce/products/5067872396581604/?ref=saved&referral_code=save_dashboard...

I’ve noticed my battery lugs are getting worn from connecting and disconnecting them from the batteries for my CUCV M1009. I already replaced them once. Is it ok to use a Battery Disconnect Switch for when I’m working on my vehicle? This would be an effort to prevent wearing out my Battery...