Search results

Ok, run about 15 gallons through the fuel lines into another fuel tank, cleaned it all up, blew air through the vent line for about 5 minutes, changed the fuel filter, and replaced the coil. Good news no vacuum in the tank. Truck ran great, drove it for over an hour, worked it hard, not a single...

How do you check voltage on the hot side of the coil when started? You have to remove the dist. cap to get to the coil. Also the resistor is inside the dist. It also has two condensors inside the dist. I ordered a new coil which should be here on Friday just in case. I am going to go through...

Gauges It is missing a couple of the nuts or what ever the four panel screws connect to and I haven't taken the time to investigate it. The screws are just laying in there loose.

I am not sure, I dont have my gauges working properly yet. If you push on the corners of the cluster panel you get oil pressure and if you push on another corner you might get the temp. It is the next step on my list of things to do. but I think its up around 30 pounds at about 1/2 to 3/4 throttle

Ok I am going to answer alot of posts. The dash tag says 1960 M45 (44,46,57,58) STK# 2320-8358196. Ser# 129849. REO DIVISION WHITE MOTOR COMPANY. The pick up tube was soaked for a week in parts cleaner and a small bore brush through it and the strainer in carb cleaner then the tube was boiled...

Ok lets try this. Everything was filled out and checked. Dont know what is going on. Filled everything out and hit submit again. So lets try it again.

Sorry I am in Vandalia Illinois. I dont Know what Happened to my signature going to check it right now!!!

m45 Tank vent, Good Idea. Didn't think of that. I am going out to try that right now.

Tank has been removed and boiled. Fuel lines appear to be clean on both ends but who knows out in the middle. It does appear to have good flow. The round tank is gone and a new square style tank is on there and it is the one that was boiled and dipped.

I have an older M45 with the gasser. My quetion is After about 30 minutes of operation it starts missing and power declines. I can drive it for about four miles and it starts spitting and sputtering. Sometimes it dies. It will restart and idles fine but it takes time to regain power and it wont...