002 and 003 Control Cabinet Screws

[dangier]

Spent a good amount of time reading in TM12 and 34 looking for how the control cabinet screws come apart. Do the cross pins just press out or is there a secret to them. Have new control panel and would like to remove and reinstall the screws without tearing them up. Can someone point me in the right direction? I am sure the answer is simple.....
Thanks,
David

 

[Jimc]

They are basically just knurled pins. They need to be pressed out of the screw shaft. I have done quite a few. Some are easy and some are hard. I just cut them off anymore and replace with dzus fasteners so you dont have to have a screw driver to open the panel

 

[dangier]

OK, thanks.