Derrickl112
Well-known member
- 2,654
- 84
- 63
- Location
- Southeast MI
.
Last edited:
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
.
- Thread starter Derrickl112
- Start date
- 3,222
- 392
- 83
- Location
- Tonopah, AZ
That is a good OOPS!!! Nice looking!!!
ARYankee
Well-known member
- 1,983
- 33
- 48
- Location
- Benton, AR
Nice. I'm glad it went to a fellow member.
DSD277
Member
- 384
- 9
- 18
- Location
- Arcadia,CA
Very nice.
You can send me the gunner's platform
... I can use it on my next "upgrade" to the FDT
And here's your spec sheet:
You can send me the gunner's platform
... I can use it on my next "upgrade" to the FDTAnd here's your spec sheet:
M925
Member
- 213
- 2
- 18
- Location
- New River Valley, Virginia
That's a sweet rig, congrats. I was watching that auction and said WOW when I saw how much that went for.
Derrickl112
Well-known member
- 2,654
- 84
- 63
- Location
- Southeast MI
.
Last edited:
quickfarms
Well-known member
- 3,495
- 25
- 48
- Location
- Orange Junction, CA
Great
Cleptomaniac
Active member
- 1,083
- 1
- 38
- Location
- Tecumseh ,OK
Way cool!!
Bolkbich
Member
- 306
- 8
- 18
- Location
- MAHWAH, NJ
Thats a nice truck...good luck with it !!!
- 34,012
- 1,808
- 113
- Location
- GA Mountains
Such misfortune. WOW.
- 2,039
- 221
- 63
- Location
- North West Arkansas
Very Nice!!!
trooper632
Member
- 533
- 3
- 18
- Location
- Utopia, TX
Is that more of a road tractor than the M931a2 (more power).
Derrickl112
Well-known member
- 2,654
- 84
- 63
- Location
- Southeast MI
.
Last edited:
Derrickl112
Well-known member
- 2,654
- 84
- 63
- Location
- Southeast MI
.
Last edited:
wsucougarx
Well-known member
- 6,951
- 67
- 48
- Location
- Washington State
Great looking truck!
DSD277
Member
- 384
- 9
- 18
- Location
- Arcadia,CA
AFAIK, one wheel on each axle will spin... I also noticed the left tire on the middle axle didn't spin while it was in the air for a brief moment, couldn't tell about the right.
You might want to jack up all 3 axles on one side and cage the brakes on that side ( The 2 downside axles still braked) and see if all 3 wheels turn when in gear... I'd hate to think you have a Front Wheel Drive only truck.
In normal mode, the drive is split 30%/70% front to rear and 50/50 in off road mode
The TM may have another way to test for torque to the rear output of the transfercase. .... since the trans is in neutral when there is no voltage to it, you may be able to jack only the 2 rear axles and "try" to turn the wheels by hand and see if the driveshaft turns.
M925
Member
- 213
- 2
- 18
- Location
- New River Valley, Virginia
I wouldn't feel too bad, that beautiful piece of equipment was going to go that high anyways.....I saw a unimog the other day go for $29K....nice truck!
I placed my final bid, then quickly walked away from the computer. After the auction was over, I saw that I had typed an extra zero.
Needless to say, this is my last MV until I am able to sell some stuff. On the upside, the truck runs great, and as far as I know, it does not need anything.
Derrickl112
Well-known member
- 2,654
- 84
- 63
- Location
- Southeast MI
.
Last edited:
Derrickl112
Well-known member
- 2,654
- 84
- 63
- Location
- Southeast MI
.
Last edited: