1967 1750 series international 5 ton running gear

[backwoodsrootin]

I'm quite new to your site and was wondering if any one can tell me what i have and where to get parts and possibly a teardown/rebuild manual.

me and my father have recently aquired some 5 ton running gear and all we have from it are a few numbers.

it's a 1967 1750 series international, believed to be a mobile communications vehicle from Veitnam, i have the numbers from the front and rear ends.
Front end:165423, 35-124, 207-256
Rear: 69013-r2-716-4
we believe that the gear ratio is 7:16

i would be greatly appreciative of any information that anyone may have to offer.
Also, thank you for the use of your forum

 

[Jetnoise400]

First off, post some photos. That will help a great deal in the identification process. And besides, everyone LOVES a good photo or two! As far as parts go, since it's an IH, try your local International dealer. I'm restoring a '42 M-3-4 IHC, and they often can find parts for my truck. As yours is 20 years newer, I suspect you'd have even more luck.

Welcome to the SS forum!

 

[jeepin]

A very good source of cornbinder knowledge can be found at the Red Power Magazine forum here: Red Power Magazine Community (Powered by Invision Power Board)

 

[backwoodsrootin]

I'll get some photos up as soon as possible , but we have called the somewhat local international dealers and they cant seem to find it in any of there systems , but we'll figure it out