- 84
- 12
- 8
- Location
- Natchitoches, Louisiana
Has anyone added an additional PTO on an M916?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
2nd PTO on M916
- Thread starter ladoublet
- Start date
- 7,409
- 2,503
- 113
- Location
- Interlachen Fl.
What were you thinking of running? My M920 had the small auxiliary ports at the base of the rear controls and double pump on it when I got it.
- 84
- 12
- 8
- Location
- Natchitoches, Louisiana
I wanted to pull a dump trailer.
Just T off the exsisting line and put a shutoff on the winch control system so that you can use the existing tank and system but it wont flow to the winch but down the frame to the dump trailer instead. Should be able to do it AFTER the control for the winch so that you could use the existing control valves.
or a pony motor/pump/tank setup for the trailer itself
Last edited:
- 84
- 12
- 8
- Location
- Natchitoches, Louisiana
Not sure if the dual pump will lift the trailer quick enough.
snowtrac nome
Well-known member
- 1,674
- 139
- 63
- Location
- western alaska
you might also look at a crank driven pump with a dry valve
Lukes_deuce
Active member
- 447
- 124
- 43
- Location
- Long Island, NY
Im not sure which 916 model you have, but the original 916 and A1 models have a second pump for aux hydraulics. From the one I looked at, the owner used those to run every trailer he had. Dump, low boy, live bottom, etc. I would check out the pump and flow rates before you try messing with the ptos. The PTOs for the Cats 7155 are hard to come by.