4A032-4 project ideas

[strycnine]

What have you guys done with your 4A032-4's?

I picked up on for a decent price.

 

[strycnine]

Here's a pic.

 

[jbk]

i installed a crate engine on my mep-16a. smooth little engine.

 

[strycnine]

Wish I could find a mep-16a that needed an engine.

Where did you get yours?

 

[jbk]

ebay. their out thier though.

 

[phil2968]

I have also. I considered putting it in a golf cart. I bought it long before I had a deuce. I like it though and will find soothing to do with it one day.

 

[Recovry4x4]

There are many of these little engines floating around. I wish someone would start parting some of them out. I need mufflers in a bad way.

 

[phil2968]

There are many of these little engines floating around. I wish someone would start parting some of them out. I need mufflers in a bad way.

For the one at the FL rally?

 

[Recovry4x4]

Yes Sir! BTW, did you get those crazy hubs installed?

 

[strycnine]

Mine didn't have mufflers.

They had over 100 units

 

[mdlbldrmatt135]

They only seem to have mufflers when attached to something..... non of the create ones have any.

 

[cranetruck]

There are many of these little engines floating around. I wish someone would start parting some of them out. I need mufflers in a bad way.

Got this muffler from the local farm tractor place...

 

[phil2968]

Yes Sir! BTW, did you get those crazy hubs installed?

Yes I did, they are keeping the road dirt out of the bearings. I left the star wheels out.
Thanks for the use of them.

 

[6x6TRex]

What have you guys done with your 4A032-4's?

I put one on a Mep-016 that needed a motor and got a spare one from a parts Mep-016 that was supposedly blowing oil out the exhaust (I haven't ran it yet).

Thinking about taking the governor off of it and either buy the stub shaft from Saturn or make my own and put it on a go-kart.

 

[m139h2otruck]

Got to watch the rpms on the little military engines, no direct oil pressure to the rod bearings just splash like a B&S. I would not run one higher than 4,000 rpm. This is why they hav'nt caught on for ultra light aircraft.

 

[m16ty]

I put one on a Mep-016 that needed a motor and got a spare one from a parts Mep-016 that was supposedly blowing oil out the exhaust (I haven't ran it yet).

Thinking about taking the governor off of it and either buy the stub shaft from Saturn or make my own and put it on a go-kart.

Let me know when you get around to fooling with it. I'm curious as to what the problem is. It does in fact blow oil out both exhaust and smokes terribly. Runs like a top other than that.