epartsman
New member
- 264
- 0
- 0
- Location
- Jacksonville/Florida
I finally got around to installing my IP and I have been pouring over the TM's and have done a few forum searchs but does anyone know which hole on the timing gear the
pin on the IP shaft goes into? Is it the round or the oval hole? The round hole does not line up and the oval does not appear to be wide enough (through blind spot camera).
I am a big guy so getting around up there is tight and awkward for me and I do not wish to make a mistake I will regret.
pin on the IP shaft goes into? Is it the round or the oval hole? The round hole does not line up and the oval does not appear to be wide enough (through blind spot camera).
I am a big guy so getting around up there is tight and awkward for me and I do not wish to make a mistake I will regret.
