802 a fuel pump

[FarmingSmallKubota]

I have an 802a with 112 hours and it was missing batteries when i got it. Also in the video from GP it was a crank no start and the no fuel light was on. I got batteries in it today and filled with fuel. No start, fuel shut off works, the screen by the fuel pump was loose and bent. took that off and the threaded piece off the top of the pump was loose. tightened and removed the bottom hard line. pump makes noise no fuel coming out. I made a mess getting some fuel in the fuel line on the top and got it to fill the fuel line and the machine ran for 2 minutes. So confident the pump is bad but wanted to share a picture because i believe some additional hard ware filters have been added as i do not see them on the tm Parts list

 

[FarmingSmallKubota]

After stumbling through past threads am i correct in the Airtex 8135 being a replacement for the main pump? the Facet pump is a little more pricey but is available, but i like lower price better.

 

[nextalcupfan]

Looks like a bit of a mess to me.

Basically all of this is non standard.
The pump also appears to be upside down.

Here is a pic of my fuel setup which I believe is all stock.

You appear to be missing a short piece of hard line and a union.

Here.

To answer your questions, yes the 8135 is a standard replacement pump and should bolt in no problems.
The problem people have is they can be kinda hard to come by so the alternative replacement is the Airtex 8131. (I put in the 8135 part # and rockauto seems to have some in stock right now however)
This is very close to the original with the only difference being the mounting is slightly different.

Also from what I've read from other users on here the square body pump is garbage and the Airtex units are far more reliable.

EDIT: I was mistaken the E1074 is the pump installed on these units to replace the facet pump.

 

[Zed254]

An Airtex E1074 came on my machine. Summit sold them once upon a time....https://www.summitracing.com/int/parts/atx-e1074/overview (it is a 24 volt pump). Note fitting on top of pump and electrical connector.

Airtex E8135 is about as close as we can get today.....https://www.amazon.com/Airtex-E8135-Universal-Electric-Fuel/dp/B0027I3K8C ....cheaper at Rockauto. The filter is an Airtex G-17.

Airtex data attached.

 

[nextalcupfan]

Zed is right about the E1074 being factory.

 

[kloppk]

The square Facet 40193 was the original factory fuel pump.
The Facet 40193 had a high failure rate so when sets were reset or repaired the Airtex E1074 was installed as a reliability upgrade.

 

[FarmingSmallKubota]

Another 802a lives thanks to a fuel pump from Light in the Dark. it also needed 2 new batteries and an air filter. Load banked it for an hour with (4) 1500 watt heaters, the wet stacking cleared. just a little haze at that load. Thanks for all the responses.

 

[Light in the Dark]

Glad I had all the parts here for you to drop it right in.