• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

An Improved, Self-Made Flare Nut Wrench for IP Removal/Installation

MarcusOReallyus

Well-known member
4,524
808
113
Location
Virginia
Sounds like a good idea!

If one has to loosen/tighten IP injection lines to the IP while it's mounted on the engine, it's a knuckle-busting, hand scraping proposition. I've found that a 5/8 inch box end wrench can be turned into a 10 point flare nut wrench that is infinitely more effective than a store-bought, normal 5 point flare nut wrench. The sacrificial wrench was an extra Craftsman 5/8"; gap made with a die grinder.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks