CCATLETT1984
New member
- 3,507
- 8
- 0
- Location
- Saint Clair Shores, MI
Mount the pump as close to the tank as you can (they push better than they pull) for wiring you can ground it to the frame, but run a wire from an ignition hot to power it.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Another fuel leak....
- Thread starter DriverSideImpact1008
- Start date
DriverSideImpact1008
Member
- 479
- 0
- 16
- Location
- Madison, WI
I was planning on running a power to ign. I would imagine they are but I figured I'll ask. Are the lines near the tank steel also? I am not near the 1008 right now and its wet out otherwise I'd look.
CCATLETT1984
New member
- 3,507
- 8
- 0
- Location
- Saint Clair Shores, MI
there are rubber lines on the crossover just behind the cab (where the lines cross to the passenger side.) putting the pump there would be a good place.
DriverSideImpact1008
Member
- 479
- 0
- 16
- Location
- Madison, WI
Ok, cool. Just looking to get some tips to make this nice and easy on my end. 