- 1,802
- 1,068
- 113
- Location
- Ostrander, Ohio
I have guy at a machine shop giving me a price to make some new steps for my deuce. I asked him to use a heavier gauge steel than the original. They'd be the same size, but they might not need the angle reinforcement on the bottom, which is where they tend to rust out anyway. He's also going to give me a price for diamond plate steel. He didn't think he would be able to do the dimples though. (I have an idea of how to do that by hand)
As long as I'm doing this, is there any interest out there for these? I haven't really seen any for sale. Anybody have a particular interest in plain, dimpled or diamond plate? I'd probably do a batch of them in primer and hardener if I got enough interest, just wanted to see if there was anybody out there that needed them.
As long as I'm doing this, is there any interest out there for these? I haven't really seen any for sale. Anybody have a particular interest in plain, dimpled or diamond plate? I'd probably do a batch of them in primer and hardener if I got enough interest, just wanted to see if there was anybody out there that needed them.