Bcurtman
New member
- 119
- 1
- 0
- Location
- Rosebud, Mo
Noticed when I tried to put the front rack on that it was too short. Looks like they need turned around.....
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Are these 105 racks on backwards??
- Thread starter Bcurtman
- Start date
3dAngus
Well-known member
- 4,719
- 101
- 63
- Location
- Perry, Ga.
You usually know for sure when you try to lock in the front to those two sides.
indy4x4fab
Banned
- 1,711
- 41
- 0
- Location
- indy, indiana
Yes, pull them up and out then turn them around and put them back in whit the wood slats facing in.
LanceRobson
Well-known member
- 1,638
- 206
- 63
- Location
- Pinnacle, Stokes County, NC
Also, if you have the panel for the rear of the trailer the rectangular brackets on the side skirts of the trailer are where you put that panel when not in use. It'll stay there without being tied down. I put mine on the driver's side so I can see it but it can go on either side.
Lance
Lance
silverstate55
Unemployable
- 2,075
- 872
- 113
- Location
- UT
I always run my wood slats inside, and the extra unused bow holders at the front of the trailer.
mikes47jeep
Member
- 369
- 13
- 18
- Location
- North East PA
wood needs to be on the inside
Bcurtman
New member
- 119
- 1
- 0
- Location
- Rosebud, Mo
Thanks to all. They will be turned around shortly!
silverstate55
Unemployable
- 2,075
- 872
- 113
- Location
- UT
No problem, and good luck! Hope they don't fit as tight as VSE rebuilds do...