jdknech
Active member
- 1,095
- 7
- 38
- Location
- Jeffersonville, Indiana
my axle boot is puking out gunk, so i got under it, and its ripped, is that something i can get at napa? i need to get this back on the road ASAP! thanks guys!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
axle boot
- Thread starter jdknech
- Start date
- 34,010
- 1,822
- 113
- Location
- GA Mountains
My local NAPA carries them but buys them from OD Iron. He only has them because of all the deuce axled buggies out here. Very unlikely that you will find them at a main stream parts house. Order at least 3, 4 if you can swing it. No better time than the present to start stocking parts.
- 8,663
- 3,036
- 113
- Location
- Monrovia, Ca.
, with the exception of MY local place having them, get a few. OD Iron, Saturn, Memphis, White Owl, e-bay will have them. Try to steer away from the New Star ones....you will replace them in a hurry. Get NOS or silicone.
- 7,584
- 365
- 83
- Location
- Cheyenne, WY
Boyce has the black silicone ones.
- 9,580
- 218
- 63
- Location
- Dickson,TN
As far as I know, all of the suppliers you listed carry the New Star brand. They may also have NOS ones though. New Star also has silicone boots but I have no idea how well they hold up.
jdknech
Active member
- 1,095
- 7
- 38
- Location
- Jeffersonville, Indiana
what is the difference in the ones with zippers, and without? one better?
littlebob
New member
- 1,548
- 26
- 0
- Location
- Baton Rouge LA
Ditto on the New Star. I got mine from OD Iron about two years ago and they're
already cracked. My truck hasn't even left the neighborhood yet! I'd love to find out more about the silicone he he has before going through that job again.
jdknech
Active member
- 1,095
- 7
- 38
- Location
- Jeffersonville, Indiana
also, should oil/grease be coming out that boot? thanks for the info so far guys! you are a heck of a group...
- 9,580
- 218
- 63
- Location
- Dickson,TN
The ones without zippers are better but you've got to tear down the whole knuckle to install them. The zipper boot can be installed without a complete teardown.
I've got a couple of extra zipper boots that I'd take $25 a piece for.
- 9,580
- 218
- 63
- Location
- Dickson,TN
If you have oil comming out of the boot you've got a bad axle seal.
jdknech
Active member
- 1,095
- 7
- 38
- Location
- Jeffersonville, Indiana
you say you CAN put the zippered ones on WITHOUT a complete teardown? and i'm guessing a bad seal is gunna be a pain.... lol
- 9,580
- 218
- 63
- Location
- Dickson,TN
You're going to have to pull the axle to replace the seal but you have to remove the whole knuckle to install a non-zippered boot. I use the zipper boots myself. They're not as good but a heck of alot easier to replace IMO.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 770
- 113
- Location
- Cincy Ohio
Have you done both Ty? I have done the zipper ones and didn't think it was that bad. For the extra protection, I'm going with the non-zipper next time.
- 9,580
- 218
- 63
- Location
- Dickson,TN
No, I've never put on a non-zippered boot but I took one look at those ball joints and decided against it. It shouldn't be too bad to install the non-zipper boots if you've got the axle already out but I guess I'm lazy
.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 770
- 113
- Location
- Cincy Ohio
Well I figured since I run through the mud once in a while, I should go for the extra bit of protection.
jdknech
Active member
- 1,095
- 7
- 38
- Location
- Jeffersonville, Indiana
so what is involved with replacing the seal? axle comes out, one or both? do you have to remove the diff? anything else i should do while i'm there?(remember the green thing out back is not a money tree, its a pit! lol)
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 770
- 113
- Location
- Cincy Ohio
If it it is the seal, that whole side of the axle will have to be taken apart. No the diff does not need to be pulled. There is a great step by step with pics thread here somewhere. let me see if I can find it.
gimpyrobb
dumpsterlandingfromorbit!
- 27,786
- 770
- 113
- Location
- Cincy Ohio
jdknech
Active member
- 1,095
- 7
- 38
- Location
- Jeffersonville, Indiana
thanks gimpyrobb! your the man!
Garandfan
Member
- 278
- 3
- 18
- Location
- Northfield, Ohio
Zipper-easier! 4 hands are better than 2. If you go with solids.... Replace the seals, repack bearings, check the wheel cylinders