zout
Well-known member
- 7,744
- 154
- 63
- Location
- Columbus Georgia
Got the section ground down so we could have a level surface for the re-enforcement piece (using what we had cut out) cleaned up the mating surfaces - laid out the bonding material and clamped her in.
Worked on the window sections cutting out where the seal slips over - rounded off these sections as well.
Started sanding down what I could working in between getting stuff done in the K as well.
Hey Swiss - your holes on the side are MIA.![DSCN0087.jpg DSCN0087.jpg](https://www.steelsoldiers.com/data/attachments/341/341240-edd7a955158a67b3762a9a7e738487ad.jpg)
![DSCN0088.jpg DSCN0088.jpg](https://www.steelsoldiers.com/data/attachments/341/341241-470a05f1eccc4e0054163abbfa5596b2.jpg)
![DSCN0089.jpg DSCN0089.jpg](https://www.steelsoldiers.com/data/attachments/341/341242-2578a591c19fb08b7fbff5acf8e8e4be.jpg)
Worked on the window sections cutting out where the seal slips over - rounded off these sections as well.
Started sanding down what I could working in between getting stuff done in the K as well.
Hey Swiss - your holes on the side are MIA.
![DSCN0087.jpg DSCN0087.jpg](https://www.steelsoldiers.com/data/attachments/341/341240-edd7a955158a67b3762a9a7e738487ad.jpg)
![DSCN0088.jpg DSCN0088.jpg](https://www.steelsoldiers.com/data/attachments/341/341241-470a05f1eccc4e0054163abbfa5596b2.jpg)
![DSCN0089.jpg DSCN0089.jpg](https://www.steelsoldiers.com/data/attachments/341/341242-2578a591c19fb08b7fbff5acf8e8e4be.jpg)