My vent tube on the cap to my brake fluid resevoir has been cut and crimped. I'm assuming this is bad? I don't know why it was cut and crimped.
1) Should I leave it alone?
2) If not, can I cut the crimped end off and secure a hose from the fitting on the cap and run the hose down below the frame somewhere? My guess is that the cap vents at certain pressure?
Thank you for any help with this...
1) Should I leave it alone?
2) If not, can I cut the crimped end off and secure a hose from the fitting on the cap and run the hose down below the frame somewhere? My guess is that the cap vents at certain pressure?
Thank you for any help with this...