can't restart after changing fuel filters on my M923A2

[Doug Roberts]

priming the pump afterwards , I am getting fuel to the injectors where I opened the line to prime to. Know any tricks I can try?

 

[Jbulach]

Make sure the batteries are still spinning the motor quickly, zip tie the fuel shutoff back temporarily, and put the throttle to the floor while cranking. It should then light, especially if you were already getting fuel at the injectors.

 

[Doug Roberts]

Make sure the batteries are still spinning the motor quickly, zip tie the fuel shutoff back temporarily, and put the throttle to the floor while cranking. It should then light, especially if you were already getting fuel at the injectors.

thanks so much. I did get it started this morning. I cracked the fuel housing and filled it up over the edge and sealed it shut , primed it again and it cranked right up.

 

[M35A2-AZ]

Did you open the blead screw on the back of the pump to let the air out? It is a 10mm bolt on the back of the pump.

 

[71DeuceAK]

Have you tried pressurizing your fuel tank yet? I've seen everything from putting a Schrader valve/air chuck in a spare fuel cap to pressurizing with an air wand filling the hole with a ratchet strap rolled up to a leaf blower.