- 653
- 533
- 93
- Location
- Reydon, OK
Is there enough room when sliding transmission and transfer case back on 4 inch bolts when changing flywheel to remove torque convertor and change front transmission seal?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Changing 400 front transmission seal
- Thread starter royalflush55
- Start date
Skinny
Well-known member
- 2,130
- 488
- 83
- Location
- Portsmouth, NH
Flexplate yes, TQ and oil seal no.
You are already 90% there, just remove it. I've used the $120 Harbor Freight junk and it worked fine of your driveway is flat.
You are already 90% there, just remove it. I've used the $120 Harbor Freight junk and it worked fine of your driveway is flat.
cucvrus
Well-known member
- 11,473
- 10,434
- 113
- Location
- Jonestown Pennsylvania
NO. You will need to drop the transmission. Just be sure that is where it is leaking. This only happened one time to me but I had a vacuum pump sucking transmission fluid and leaking down the back of the bell housing. Just check all the options. Other transmission leaks can occur up top are the vent can leak at high speed when the internal pressure of the transmission increase with heat and slippage. I just had an M1009 repaired for that condition. Good Luck. And make sure you have the torque converter properly seated in the front pump. No force needed.