-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Changing engine??
- Thread starter zb39
- Start date
clinto
Moderator, wonderful human being & practicing Deuc
Staff member
Administrator
Super Moderator
Steel Soldiers Supporter
Supporting Vendor
- 12,596
- 1,133
- 113
- Location
- Athens, Ga.
It's a breeze! Follow the TM........
I had to put a clutch in mine and before I replaced it, I attempted to adjust the pressure plate several times, so I have a LOT of experience pulling the engine in and out.
Very simple, with some exceptions. The aircleaner and muffler nuts are hard to get to, they will require some wobbly and u-joint extensions and patience.
Once everything is loose, put a 2 x 4 under the oil pan and roll a floor jack under it, slightly lower the engine and slide back. GO SLOW.
Putting it back is the reverse. I did it by myself after the first few tries.
I had to put a clutch in mine and before I replaced it, I attempted to adjust the pressure plate several times, so I have a LOT of experience pulling the engine in and out.
Very simple, with some exceptions. The aircleaner and muffler nuts are hard to get to, they will require some wobbly and u-joint extensions and patience.
Once everything is loose, put a 2 x 4 under the oil pan and roll a floor jack under it, slightly lower the engine and slide back. GO SLOW.
Putting it back is the reverse. I did it by myself after the first few tries.
Attachments
- 7,584
- 363
- 83
- Location
- Cheyenne, WY
Like Clinto said, it's easy. The biggest thing is install/set the clutch up correct or you will get alot of practice pulling/installing the engine.