mm58
Member
- 90
- 9
- 8
- Location
- Tucson/Arizona
I've got a VIC-1 system setup in my vehicle. I only use it for intercom, but have a civilian CB radio's
audio connected into the "AUDIO INPUT" wire terminals. No MIL radios installed.
I can listen to the CB while wearing headsets, but must still use the hand mic to transmit.
I've also got an LS-671 loudspeaker that I'd also like to connect into the system.
* When I connect the -671 to any open jack on the AM-1780, all I hear thru the speaker is UNamplified.
* Power switch is ON and green pilot light is also ON.
* Volume knob on the -671 is pulled out and turned up.
* When power is switched off, audio reverts back to headset.
How do I get the audio coming out of the -671 to be AMPLIFIED??
Any help appreciated
Mike
audio connected into the "AUDIO INPUT" wire terminals. No MIL radios installed.
I can listen to the CB while wearing headsets, but must still use the hand mic to transmit.
I've also got an LS-671 loudspeaker that I'd also like to connect into the system.
* When I connect the -671 to any open jack on the AM-1780, all I hear thru the speaker is UNamplified.
* Power switch is ON and green pilot light is also ON.
* Volume knob on the -671 is pulled out and turned up.
* When power is switched off, audio reverts back to headset.
How do I get the audio coming out of the -671 to be AMPLIFIED??
Any help appreciated
Mike
Last edited: