Just trying to wrap my head around the different control boxes, gave the search a go but I'm still confused. My 1151 has a Nartron box. Every time I turn it to run, the wait light comes on for a few seconds whether the truck was sitting for a few days or just shut off a minute before. I finally drove my 1097 on the road for the first time yesterday, has a KDS yellow label box. A cold start the wait light comes on for a couple seconds just like my other truck. Sitting for an hour or so the wait light only illuminated for a second. An almost immediate restart it flashes and goes out. Both trucks start every time without issue/hesitation. 1097 operated the same way last night and this morning. Does that sound normal?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Control box differences
- Thread starter Greg841
- Start date
- 3,596
- 3,518
- 113
- Location
- Brooklyn, NY
Different boxes. Different manufacturers. Different behaviors.
- 7,015
- 9,693
- 113
- Location
- Papalote, TX
It sounds like you have a non functional TSU or a mismatched TSU
Here is the link to the sticky where you can see what TSU you need for your PCB
https://www.steelsoldiers.com/threads/pcb-eess-smartstart-s3-i-pics-info.164930/
I have never seen a wait light when fully warmed up (other than a flash), but then I probably have not been exposed to every box out there but IMHO that does not sound right.
Here is the link to the sticky where you can see what TSU you need for your PCB
https://www.steelsoldiers.com/threads/pcb-eess-smartstart-s3-i-pics-info.164930/
I have never seen a wait light when fully warmed up (other than a flash), but then I probably have not been exposed to every box out there but IMHO that does not sound right.