- 10,350
- 75
- 48
- Location
- Meadows of Dan, Virginia
Cutting and glueing progressively smaller rings of plywood can work too. The piece could be finished in a wood turning lathe.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Desplined hubs?
- Thread starter Stretch44875
- Start date
- 10,350
- 75
- 48
- Location
- Meadows of Dan, Virginia
A brass/bronze bushing could then also be installed.
Blake
Active member
- 321
- 60
- 28
- Location
- Opp, Alabama
Ouverson engineering locking hubs are done. Mine came in today and look killer!
rdixiemiller
Active member
- 1,760
- 3
- 38
- Location
- Olive Branch Mississipi
The only problem with wooden ones is getting a piece of wood that will not split or check. The labor is not too bad, I make wooden objects on my metal lathe all the time. Metal lathes allow more precision than is normally encountered on wood lathes. All you need to do is grind your tool bits to the proper angles.