Dually centers on HEMTT rims

[lakeydna]

got them to work. Overall width of the truck is not that wide as compared to the tank. Didn't have a tape measure but no where near as wide as a 812/945.
I would hazard a guess at 9'. There was about 2" each side sticking out past wheel fenders on the rear. Large wheel gap which could definitely be reduced. This truck had a rubber block suspension.

 

[tucker79]

View attachment 539598View attachment 539599View attachment 539600

The picture of the dual gap wouldn't upload. The inside rears are the same as the front, and the outer is re-centered with a piece of pipe. You might get away with a FMTV wheel inboard and a bridge truck wheel outboard.

Is That just inside wheel bolted on with outside rim welded on with a pipe???

 

[lakeydna]

Is That just inside wheel bolted on with outside rim welded on with a pipe???

No the pipe is welded on the outer wheel with the center moved out. Like making a dually wheel out of a fmtv or combat wheel. Still two centers bolted to the hub.