- 3,222
- 392
- 83
- Location
- Tonopah, AZ
I was a contractor.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
F-111 Aardvark - Brenham, Texas
- Thread starter m715mike
- Start date
- 16,768
- 24,102
- 113
- Location
- Burgkunstadt, Germany
What firm? My Father was Autonitics. He did the F111 logistics, and the Terrain Following Radar. Was at Hill AFB.
- 3,222
- 392
- 83
- Location
- Tonopah, AZ
I was working for Texas Instruments in Dallas, TX.
- 6,556
- 13,940
- 113
- Location
- Hawthorne, NV.
I just HAVE to ask what type of obstacles had to be overcome to tow that rascal with the wings on?? I've done LOTS of oversize/overweight towing.....but....gosh!!
papabear
GA Mafia Imperial 1SG
- 13,520
- 2,464
- 113
- Location
- Columbus, Georgia
Thank you Sir....I just KNEW it had to be a well coordinated super human effort with lots of eyes and support.I just HAVE to ask what type of obstacles had to be overcome to tow that rascal with the wings on?? I've done LOTS of oversize/overweight towing.....but....gosh!!!
i didn’t do the towing, I only helped with wheel bearings and locating tires/wheel o-rings. Joe did the towing with the help of lots of other folks, it took most of the day to go the few miles. Joe also built the tow bar, display stands to hold the aircrafts weight once in place, and the painting. There were 4 narrow bridges to cross, 2 decent hills, and lots of trees and fence posts that had to be cut, a fence had to be taken down and a ditch filled in just to get it out of the airport. At one point they had to soap the road and slide it over with a big rotator truck bc they were going to clip a hillside with a wing.