Ford Mechanic
Active member
- 1,805
- 7
- 38
- Location
- Edenton, NC
I would like to test/adjust/rebuild and clean my injectorsbut have some questions.
Anyone out there got the Injector rebuild TM or info otherwise on how to do it? I haven't seen that info in the TM's I have down loaded. I have axcess to a pop tester that I just have to adapt to my injectors.
What's the best pressure to set them at? I read in a TM 3000psi but have seen other post they set theirs at 3500psi, was there a reason or big differance afterwards?
And lastly I'd like to check compession while they're out, anyone got suggestions how to cobble together something to check it? Or by chance might have the military one that you wouldn't mind loaning out at my expence of course?
I also plan on thoughly looking into all cyinders with a bore scope while all is apart.
Anyone out there got the Injector rebuild TM or info otherwise on how to do it? I haven't seen that info in the TM's I have down loaded. I have axcess to a pop tester that I just have to adapt to my injectors.
What's the best pressure to set them at? I read in a TM 3000psi but have seen other post they set theirs at 3500psi, was there a reason or big differance afterwards?
And lastly I'd like to check compession while they're out, anyone got suggestions how to cobble together something to check it? Or by chance might have the military one that you wouldn't mind loaning out at my expence of course?
I also plan on thoughly looking into all cyinders with a bore scope while all is apart.