DatGuyC
Member
- 537
- 22
- 18
- Location
- Essex, Maryland
I'd ask how its supposed to be done since the 24 bolt wheels don't have the centering hole?
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Only $9.78 at Lynch.Don't see how those would work any better than the tapered nuts and at $13 each from HPG I'm not about to find out haha
There are three holes, spaced at 120° which are a tad under Ø15.0mm. All other 21 holes are Ø16.0mm. Now... the protruding, knurled area on the studs measures 14.1mm, which leaves us with almost 1 mm of radial play, between both halves. While that doesn't sound to be much, it still is enough to a) best case: compensate- or at least reduce the radial run-out of the inner rim; or b) worst scenario: increase the run-out to possibly exceed 1/8"...(!)I'd ask how its supposed to be done since the 24 bolt wheels don't have the centering hole?
I had a bunch back then. I probably have them tucked away for the last 15 years.When the original postings were done on the G503 site Lynch Hummer was selling those washers for $.54! I know because I bought a bag of them.