Heavy Duty Receiver Hitch Measurements?

[galaxie428]

I would like to put a receiver hitch on my Humvee. I have found a couple on the auction site and the big "A" that look decent. I wondered if any of you that has one of these could take a measurement for me? I am curious what the dimension is from the floor to the inside bottom of the receiver. I would like whatever I buy to be the same or close to my regular truck so I don't have to adjust the trailer between vehicles. My 5 ton is the same height as my truck. I will fab one of my own up if this one is not close.

This is the one on the big "A".


My regular truck is around 20 3/4.


What is this dim?

 

[galaxie428]

Let's try this again with pictures that work.

 

[galaxie428]

This must not be a very popular option if none of you have one of these. I thought you guys had all the answers on here!

I will do some looking to see what others are doing for hitches then.

 

[StackJ]

There are quite a few out there. I made my own, welding a HF under bumper receiver to the bottom of my pintle. I'm assuming the lack of response means that most folks hope for somewhere in a range and call it good.

 

[DatGuyC]

I have the factory hitch off a H1. I could get you measurements if you think they would be useful.

 

[Action]

Does it matter how high the square hole is? You just buy the correct piece that adjust the ball height and stick it in the hole. Or, am I missing something?

 

[galaxie428]

I was trying to keep from buying yet another hitch or multiple hitches since I need a ball and a pintle. I would like to use what I already have.

I think I am just going to order the receiver that I posted above. Thanks for everyone's help.