• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Humvee Fuel Tank Overfill Causing a leak?

Hummer Guy

Well-known member
843
807
93
Location
United States Louisiana
https://www.psmagazine.army.mil/News/Article/2549126/hmmwv-dont-overfill-fuel-tank/ I just seen this article and find it pretty strange. So, we should only be filling up to 3/4 of a tank? I had filled mines up last week and notice a small leak from the top, I thought my tank was possibly be cracked at the top.

On a 2nd note, have anyone ever installed that 17 gallon AUX fuel tank? If so, where is it installed at? I been looking at getting that myself but never pulled the plug on it because of how much it cost
 

Coug

Well-known member
Steel Soldiers Supporter
2,975
4,355
113
Location
Olympia/WA
aux tank gets installed behind the rear diff, so same location as the pioneer tool kit.

system is supposed to be sealed, because supposedly it can be run in 5 feet of water. If gravity is enough to make it leak fuel, then something isn't right.
 

juanprado

Well-known member
Steel Soldiers Supporter
5,614
2,922
113
Location
Metairie/La (N'awlins)
I have the complete kit as it is extensive- Additional gauge and wiring, Extra filler neck, cap, and bucket, specific bumper brackets, Fuel Lines, tank etc

and "might " consider letting it go. Also I am down the road and I think we can work out a handoff... If interested, send me a p,m
 

Hummer Guy

Well-known member
843
807
93
Location
United States Louisiana
I have the complete kit as it is extensive- Additional gauge and wiring, Extra filler neck, cap, and bucket, specific bumper brackets, Fuel Lines, tank etc

and "might " consider letting it go. Also I am down the road and I think we can work out a handoff... If interested, send me a p,m
For some reason, I thought that connects to the main tank, so its kind of like the H1 AUX with being a completely different tank?
 

papakb

Well-known member
2,285
1,185
113
Location
San Jose, Ca
It's a well known fact that when the coupling between the filler neck and the tank either loosens up or cracks from dry rot the tanks leak when filled. Get up under the vehicle and check the hoses and clamps. Remember some of these trucks are now going on 37 years old and rubber doesn't last forever especially when it sits in the sun day after day.
 

juanprado

Well-known member
Steel Soldiers Supporter
5,614
2,922
113
Location
Metairie/La (N'awlins)
I am not familiar with H1, but is a separate independent tank with its own fuel line and vent lines plus filler neck. I have not looked at the install manual recently if I recall 150 pages or so but seem to remember it has a valve and switch but I am foggy on that detail.
 

Mullaney

Well-known member
Steel Soldiers Supporter
Supporting Vendor
7,716
19,766
113
Location
Charlotte NC
https://www.psmagazine.army.mil/News/Article/2549126/hmmwv-dont-overfill-fuel-tank/ I just seen this article and find it pretty strange. So, we should only be filling up to 3/4 of a tank? I had filled mines up last week and notice a small leak from the top, I thought my tank was possibly be cracked at the top.

On a 2nd note, have anyone ever installed that 17 gallon AUX fuel tank? If so, where is it installed at? I been looking at getting that myself but never pulled the plug on it because of how much it cost
.
Kinda have to agree with the rest of the guys...
Either a loose clamp or dry rotted hose on the filler neck or on the tank itself. (or both)
 

Maxjeep1

Well-known member
Steel Soldiers Supporter
1,338
1,916
113
Location
Las Vegas Nevada
Square rubber gasket for the plate that sits on top of the tank. I was able to take the inspection cover off of the body and I could see cracks in it. Probably other things are leaking too but I had a waterfall on both sides of the tank…
 

Retiredwarhorses

Well-known member
Steel Soldiers Supporter
4,397
4,181
113
Location
Brentwood, Calif
Square rubber gasket for the plate that sits on top of the tank. I was able to take the inspection cover off of the body and I could see cracks in it. Probably other things are leaking too but I had a waterfall on both sides of the tank…
the filler neck rubber is notorious for failure after year of having Fuels sit in the hose and soften it up, the clamps loosen up and you have leaks. I probably do a fuel tank once a month, never seen the top plate leaking it’s always a filler neck issue, you will see cracking on the exposed edge of the top plate gasket, but that doesn’t seem to extend inwards to the entire gasket. Parking on a driveway after filling up will definitely test your tanks worthiness.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks