• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Humvee has replaced injector pump--air leaking in somewhere

gem1410

Active member
526
44
28
Location
TOMS RIVER NJ 08527
I replaced the injector pump on a 6.2--old pump had a fuel leak that filled the valley but engine did run well--put on new pump and engine ran well for a short time and now misses as if air is getting into fuel line--bled all injectors still has rough idle--Is there a way to bleed the pump at the rubber line where the injector fuel return line is--thanks George
 

ken

Active member
Steel Soldiers Supporter
2,479
25
38
Location
Houston Texas
Is the pump you installed a rebuilt pump? To answer your question, No the return line is just that. It is open to the on the other end in the fuel tank. You may still have some air in the supply line from the tank. Try bleeding again. You mey need to run it at a higher PRM until it smooths out.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks